Beverage Selection (Acceptance Of Factory Settings) - WMF combiNation S/S4/ESeries 8600 Operating Instructions Manual

In the example shown here, the sequence selected was cof-
fee , froth
Coffee Foam
soft key at any time during setting, you can activate a
Test
test brew to check the result of the changes you have made
to the settings. Press the
tings, or press to quit the settings menu without accept-
ing the changes.

8.2.8 Beverage selection (acceptance of factory settings)

To set or alter which beverage is allocated to a beverage
key on the control panel, enter the beverage settings menu
(see chapter 8.2 on page 115) choose the setting mode for
the beverage selected and use the
scroll to the setting page where the
pears. Then press the
The following display appears. This list contains around 40
standard beverage settings which you can allocate to the
individual beverage keys. By using the
keys you can scroll one page forward or back through the
list until you find the beverage you are looking for.
Important!
When you alter the beverage selection, the individ-
ual settings are overwritten by the default values for
the beverage selected (factory settings).
If you only want to alter the settings for a beverage
key which has already been allocated, skip this set-
ting step.
If you want to allocate a new beverage to a beverage key
on the control panel, press the name of your desired bever-
age on the list soft key.
In the example shown here, the beverage selected was
Latte Macchiato. Press the
settings, or press
cepting the changes.
and finally milk
Milk
soft key to accept the new set-
and/or
Beverage
soft key.
Beverage
soft key to accept the new
to quit the setting menu without ac-
. By pressing the
soft keys to
soft key ap-
and/or arrow
121