Quantity Pre-Selection; Manual Input - WMF combiNation S/S4/ESeries 8600 Operating Instructions Manual

4. At the end of the brewing process, the freshly prepared
coffee beverage is ready. The used coffee grouts are
collected in the built-in grouts collector 12. All the key
lights are reactivated again and the display shows the
"Ready" message. The machine is ready for the next
brewing operation.

7.6.3 Quantity pre-selection

If you wish to prepare several cups one after the other, you
can repeat each beverage selection automatically up to 12
times. By using the two-cup function
pre-selection you can, for example, prepare 12 x 2 = 24
beverages one after the other.
Once the first brewing has started, the quantity pre-
selection (number) of beverages to be dispensed can be
increased or decreased by pressing the
key as appropriate.
In the example shown here, a Latte Macchiato was selected
and the quantity increased to 6 using quantity pre-selection.
The display shows the pre-selection and progress of brew-
ing (in this example: the first of six brews is taking place).
Six brewing cycles are now carried out, one after the other.
Remember to place a fresh cup under the combination
spout each time. The quantity pre-selection can be altered
while brewing is in progress. Once all the brews have been
completed, the "Ready" message appears again in the dis-
play.

7.6.4 Manual input

The machine is equipped with a manual input
coffee to prepare additional coffee beverages (e.g. mild
coffee or decaffeinated coffee). To use the manual input,
proceed as follows:
1. The machine is ready and the following message ap-
pears in the display. Place the appropriate container be-
neath the combination spout. Then press the
key to unlock the manual input 3.
98
2x
and quantity
or soft
3 for ground
soft