Table of Contents
Advertisement
Insert the connector of milk intake hose
tion provided on the underside of the combination spout 7.
Then push the milk intake hose into the guide on the under-
side of the combination spout
hose
16
to the combination spout 7.
Next, feed the milk intake hose
valve
13
mounting. To do this, pull both ends of the milk
intake hose
16
forward and press down into the mounting.
Then guide the metal nozzle of the milk intake hose
through the hole which is on the left next to the clamping
valve 13. Finally, insert the metal nozzle of the milk intake
hose
16
into the milk tank supplied (e.g. in the
WMF auxiliary cooler or Tetra Pak).
Always make sure the milk tanks are topped up or replaced
in good time, to ensure correct operation of the coffee ma-
chine.
6.4
Beverage key selection and labelling
Depending on the machine version chosen, you have either
5 or 9 beverage keys and one hot water key at your dis-
posal (shown here: control panel
17). You can assign each beverage key
with your chosen coffee beverages. Around 40 pre-set
standard beverages are provided for you (see chapter 7.2.8,
page 120) or alternatively you can choose your own set-
tings.
You can label the individual beverage keys
ent beverage symbols which your local WMF customer
service engineer can replace according to your require-
ments.
92
16
into the connec-
7
to fasten the milk intake
16
through the clamping
5
with 9 beverage keys
17
individually
17
with differ-
7
16
13 13
16
16
16
13
5
17
Advertisement
Table of Contents
