Table of Contents
Advertisement
2
Getting Started
A. Design and Installation Considerations
The Palazzo series gas appliance is designed for outdoor
use and may be installed as a stand alone unit or built
into a wall. It may be installed in screened porches and
lanais that meet these minimum requirements:
• Minimum porch area - 96 square feet
• Minimum ceiling height - 88 in.
• Minimum distance from top of appliance opening to
ceiling - 50 in.
A minimum of two walls can be screened but must be
open to outside ventilation. Minimum requirements are:
• Minimum screen area - 64 square feet
• Minimum screen top height - 80 in.
If this appliance is to be installed within a wall, you
must:
• Provide access to the gas controls.
• Slope outdoor floor (and hearth) away from appliance.
• Flash the perimeter of the appliance, corners and the
appliance face in a manner consistent with regional
practices as required to prevent water penetration
around the appliance or manage water that may
penetrate the appliance. See Section 3 for more
information regarding wall and enclosure construction.
The appliance may be installed on a wood or noncom-
bustible deck.
Refer to Section 3 for clearances.
Installation MUST comply with local, regional, state and
national codes and regulations. Consult the authorities
having jurisdiction over restrictions, installation inspec-
tion and permits.
Before installing, determine the following:
• Where the appliance is to be installed.
-
Clearance to side walls
-
Location of indoor appliance terminations, air inlets,
gas meters, etc.
-
Doors
- Location of the fireplace to a door that swings open
to ensure it does not interfere with the fireplace when
opened
-
Windows
-
Walkways
-
Wires
- Possibility of flooding or running water
• Gas supply piping requirements.
• Electrical wiring requirements.
• Framing and finishing details.
Outdoor Lifestyles by Hearth & Home Technologies • Palazzo Installation Manual • 4082-311 Rev. A • 06/08/15
Installation and service of this
appliance should be performed by
qualified personnel. Hearth & Home
Technologies recommends HHT
Factory Trained or NFI certified
professionals.
Improper installation, adjustment, alteration, service or
maintenance can cause injury or property damage. For
assistance or additional information, consult a qualified
service technician, service agency or your dealer.
B. Tools and Supplies Needed
Before beginning the installation be sure that the following
tools and building supplies are available.
Tape measure
Framing material
Pliers
Hammer
Phillips screwdriver Manometer
Gloves
Framing square
Voltmeter
Electric drill and bits (1/4 in.)
Plumb line
Safety glasses
Level
Reciprocating saw
3/4 in. wrench
Crescent wrench
7/8 in. wrench
1/4 in. nut driver
7/16 in. wrench
Pipe sealant
Flat blade screwdriver
Non-corrosive leak check solution
1/2 - 3/4 in. length, #6 or #8 Self-drilling screws
Caulking material (300ºF minimum continuous exposure
rating)
5
Advertisement
Table of Contents
