Table of Contents
Advertisement
2 2
Getting Started
A. Design and Installation Considerations
Installation MUST comply with local, regional, state and
national codes and regulations. Consult insurance carrier,
local building inspector, fire officials or authorities having
jurisdiction over restrictions, installation inspection and
permits.
Before installing, determine the following:
• Where the firebox is to be installed.
• Gas supply piping requirements.
• Electrical wiring requirements.
• Framing and finishing details.
• Whether optional accessories - are desired.
►
The Vesper series gas appliance is designed for outdoor
use and may be installed as a stand alone unit or built into
a wall. Install on wood, composite or non-combustible flat
surface, extending full width and depth of the appliance to
prevent damage.
Outdoor spaces - For the purpose of these instructions,
an appliance is considered to be outdoors if installed with
shelter no more inclusive than:
1. With walls on all sides, but no overhead cover
2. Within a partial enclosure which includes an overhead
cover and no more than two side walls. These side walls
may be parallel, as in a breezeway, or at right angles to
each other; or
3. Within a partial enclosure which includes an overhead
cover and three sidewalls, as long as 30 % or more of the
horizontal periphery of the enclosure is permanently open.
NOTE: Screen may be used on the open sides of the shel-
ter. 14x18 and 16x18 screen mesh is approved for use. DO
NOT use solar screen or no-see-um screen.
If appliance does not meet the above requirements, it must
have a Z21.11.2 unvented heater installed.
NOTE: See page 6 for additional information on appliance
locations requirements for outdoor living spaces.
Installation and service of this appliance should be performed by
qualified personnel. Hearth & Home Technologies recommends
HHT Factory Trained or NFI certified professionals.
Improper installation, adjustment, alteration, service or
maintenance can cause injury or property damage. For
assistance or additional information, consult a qualified
service technician, service agency or your dealer.
Outdoor Lifestyles • VOFB36/42 Installation Manual • 4153-901 • Rev B • 04/23
B. Tools and Supplies Needed
Before beginning the installation be sure that the following
tools and building supplies are available.
Tape measure
Pliers
Phillips screwdriver
Gloves
Electric drill and bits
Safety glasses
Reciprocating saw
Caulking material (300ºF minimum continuous exposure
rating)
Note: Refer to the installation instructions provided with
the log set for items required for log set installation.
C. Inspect Firebox and Components
• Carefully remove the firebox and components from the
packaging.
• Report to your dealer any parts damaged in shipment.
• Read all of the instructions before starting the instal-
lation. Follow these instructions carefully during the
installation to ensure maximum safety and benefit.
WARNING! Risk of Fire or Explosion!
could impair safe operation. DO NOT install damaged,
incomplete or substitute components. Keep firebox dry.
Hearth & Home Technologies disclaims any responsibility
for, and the warranty will be voided by, the following actions:
• Installation and use of any damaged firebox or system
component.
• Modification of the firebox.
• Installation other than as instructed by Hearth & Home
Technologies.
• Improper positioning of the gas logs.
• Installation and/or use of any component part not approved
by Hearth & Home Technologies.
Any such action may cause a fire hazard.
WARNING! Risk of Fire, Explosion or Electric Shock!
DO NOT use this firebox if any part has been under water.
Call a qualified service technician to inspect the firebox
and to replace any part of the control system and/or gas
control which has been under water.
Framing material
Hammer
Level
Framing square
Damaged parts
5
Advertisement
Table of Contents
