Rear Panel Features - Pearl RBM-20 Quick Start Manual

EPC-14T PLASTIC RIDE CYMBAL USERS!!!
The Ride Cymbal Trigger Settings are pre-set at the factory for
E-Classic Metal RIDE cymbals. If you're using an E-Classic
Metal RIDE cymbal you don't have to do anything.
However, if you're using an EPC-14T Plastic RIDE cymbal,
please follow the steps below to optimize playability.
1. Press TRIG EDIT to enter the main Trig. Edit Menu page.
The first page shown should be INP (F1).
2. Highlight the instrument at the top of the screen using the
CURSOR UP/DOWN buttons then use the DEC- / INC+
buttons or VALUE/TEMPO DIAL to change it to RideBell.
3. Use CURSOR UP/DOWN to move through the menu items
and select InputType.
4. Use the DEC- / INC+ buttons or the VALUE/TEMPO DIAL
and change PIEZO to SWITCH.
5. Press the SAVE button to save this setting.
6. Press KIT SELECT to continue playing.

REAR PANEL FEATURES

9
9
1
2
1. POWER SWITCH – Turns the module on and off.
2. POWER IN – Connect the included AC adapter to this input, then
connect the adapter to a power source.
3. MAIN OUT – Use 1/4" TS cables to connect these outputs to an
amplifier or speaker system.
controlled by the MAIN VOL knob on the top panel.
4. AUX OUT – Use a 1/4" TS cables to connect these outputs to a monitor system or recording device.
The AUX OUT signal can be set to be identical to or independent of the MAIN OUT signal.
5. AUX IN – Connect an external sound source, such as a CD player, to these inputs using a stereo pair
of RCA cables.
6. USB – Use a standard USB cable to connect the module to your computer via this USB port. This
connection allows the module to send MIDI messages via USB to an external drum software module.
You can also transmit SysEx files over this connection.
7. MIDI IN – Use a standard five-pin MIDI cable to connect this input to the MIDI OUT of an external MIDI
device.
8. MIDI OUT – Use a standard five-pin MIDI cable to connect this output to the MIDI IN of an external
MIDI device.
9. TRIGGER INPUTS – Connect the triggers of your drum kit to the
appropriate inputs here.
cymbals (e.g., a drum with head and rim triggers or a cymbal with
bow and bell sounds) will require TRS cables to trigger both zones.
IMPORTANT NOTICE FOR
9 9 9 9
9 9 9 9
The volume of these outputs is
Please note that dual-zone pads or
9
7 6
8
9 9
3
5 4 3
5 4 3
WARNING: Use only the
included Pearl power supply
with the RBM-20 module.
Note: The module's HI-HAT
CONTROL TRIGGER INPUT
does not support keyboard-
style expression pedals.