Brother DCP-T300 Basic User's Manual page 53

Error Message
Out of Memory
Paper Jam
Wrong Paper Size
Cause
The machine's memory is full.
The paper is jammed in the machine. Remove the jammed paper by
Paper dust has accumulated on the
surface of the paper pick-up rollers.
The Paper Size setting does not
match the size of paper in the tray. Or,
you did not set the paper guides in the
tray to the indicators for the paper
size you are using.
Troubleshooting
Action
If a copy operation is in progress:
 Press Stop/Exit and wait until the
other operations that are in
progress finish, and then try
again.
 Press Mono Start or
Colour Start to print the pages
scanned so far.
following the steps in Printer jam or
paper jam on page 47.
Make sure the paper length guide is
set to the correct paper size.
DO NOT extend the paper tray when
you load A5 or smaller size paper.
(The extendable tray is only available
for some countries.)
If there is a repeat paper jam, a small
piece of paper may be stuck in the
machine. Make sure paper is not still
jammed in the machine. (See
Additional paper jam clear operations
on page 50.)
Clean the paper pick-up rollers.
(See Advanced User's Guide:
Cleaning the paper pick-up rollers.)
1 Check that the Paper Size you
chose matches the size of paper
in the tray.
(See Paper Size on page 16.)
2 Make sure you loaded the paper
in a Portrait position, by setting
the paper guides to the indicators
for your paper size. (See Loading
paper and other print media
on page 10.)
3 After you have checked the paper
size and the paper position, press
Mono Start or Colour Start.
If you are printing from your
computer, make sure the paper size
you chose in the printer driver
matches the size of paper in the tray.
(See Software and Network User's
Guide.)
B
45