Brother DCP-T300 Basic User's Manual page 52

Error Message
Ink Low XXXXXXX
Low Temperature
No Paper Fed
44
Cause
The amount of remaining ink in one or
more of the ink tanks is low.
This error message may appear if the
ink dot counter is incorrect even if a
lot of ink remains.
The room temperature is too low.
The machine is out of paper or paper
is not correctly loaded in the paper
tray.
The paper tray was not fully inserted. Remove the paper tray and re-install
Paper dust has accumulated on the
surface of the paper pick-up rollers.
The Jam Clear Cover is not closed
correctly.
The paper is jammed in the machine. Remove the jammed paper by
Action
Look through the see-through cover
of the ink tank to assess the actual
amount of remaining ink.
If the remaining ink level is at or below
the lower line under the triangle mark,
refill the ink tank.
A message may appear on the LCD
to verify whether the ink tanks were
refilled.
Press a (Yes) to reset the ink dot
counter if ink tank has been refill.
Press b (No) if ink tank has not been
refilled.
(See Refilling the ink tanks
on page 33.)
After increasing the room
temperature, allow the machine to
warm up to room temperature and
then try again.
Do one of the following:
 Refill the paper in the paper tray,
and then press Mono Start or
Colour Start.
 Remove and reload the paper,
then press Mono Start or
Colour Start. (See Loading
paper and other print media
on page 10.)
it until it locks into place, and then
press Mono Start or Colour Start on
the control panel.
Clean the paper pick-up rollers.
(See Advanced User's Guide:
Cleaning the paper pick-up rollers.)
Make sure the Jam Clear Cover is
closed evenly at both ends. (See
Printer jam or paper jam on page 47.)
following the steps in Printer jam or
paper jam on page 47.
If this error occurs often during
2-sided printing, the paper feed
rollers may be stained with ink. Clean
the paper feed rollers.
(See Advanced User's Guide:
Cleaning the paper feed rollers.)