Charging Procedure - Titan TTI526COM Safety And Operating Manual

Fig. 1-1
Fig. 1-2
Fig. 3

CHARGING PROCEDURE

NOTE: Before using the tool, read the
instruction book carefully.
INTENDED USE
This cordless combi drill shall be used for
drilling metal or wood or similar materials, and
occasionally for impact drilling on masonry or
similar materials. Other uses for the tool will lead
to the damage of the tool and a series of dangers
to the operator. This tool is intended for DIY home
use, or occasional professional use.
BEFORE USING YOUR CORDLESS DRILL
Your battery pack is UNCHARGED and you must
charge once before use. When you charge the
new battery or one which has not been used for
long periods of time, it may not reach full charge
until after you have discharged it fully in use and
recharge it several times.
WARNING: The charger and battery pack are
specifically designed to work together so do not
attempt to use any other devices. Never insert or
allow metallic objects into your charger or battery
pack connections because an electrical failure and
hazard will occur.
1. TO CHARGE THE BATTERY PACK (Fig. 1)
WARNING: Only use charger TTB528CHR
to charge battery TTB527BAT.
Insert the charger plug into a suitable mains ocket,
the power indicator will light green, connect the
charger base to charger, the base green light on.
Insert the battery pack into base , the base red
light turn on that the charging is taking place.
When fully charged, the red light will turn off.
Unplug the charger and remove the battery pack.
WARNING: When battery charge runs out
after continuously use or exposure to direct
sunlight or heat, allow time for the tool to cool
down before re-charging to achieve the full charge.
The green light is always on when contact power.
only when charging the base red light is on. If the
red light off when slide battery pack into base,
maybe the pack at high temperature or pack is
defection. Need do further check. To judge the
battery on charging or not, just need check base
red light is on or off.