Ignition Switch - Piper Cherokee SIX 300 Service Manual

PIPER CHEROKEE SIX SERVICE MANUAL
C216
J1A (RIGHT MAG)
69050-133
(GND)
J2A (LEFT MAG)
NOTE:
1. CONNECTING LINK NOT USED ON PA 32R-300
Figure 10-32a. Ignition Switch
10-76. IGNITION SWITCH.
10-77. REMOVAL OF IGNITION SWITCH.
a.
Insure the ignition switch is in the OFF position.
b. Gain access to and disconnect the power lead (+) from the battery.
c. Remove the ignition switch, retaining nut from the switch on the forward side of the instrument
panel and withdraw the switch from the panel.
d. Mark the wires and note their position on the switch, then disconnect the wires.
10-78. INSTALLATION OF IGNITION SWITCH. (Refer to Figure 10-32a.)
a. Attach wires to switch as shown in Figure 10-32a.
b.
Position the ignition switch in the instrument panel and secure with retaining nut.
c. Connect the power lead (+) to the battery and reinstall any access covers previously removed.
ELECTRICAL SYSTEM
Added: 8/3/81
3C24
0