Piper Cherokee SIX 300 Service Manual page 753

PIPER CHEROKEE SIX / LANCE SERVICE MANUAL
TABLE III-I. INSPECTION REPORT - PA-32-260/300 (cont.)
NATURE OF INSPECTION
B. ENGINE GROUP (CONT.)
32. Inspect operation of vacuum pump and security of lines. (See Notes 27 and 32.)
33. Inspect throttle, alternate air, mixture, and propeller governor controls
for security, travel, and operating condition. (See Note 19.) .................................
34. Inspect exhaust stacks, connections and gaskets.
Replace gaskets as required ...................................................................................
35. Inspect exhaust system per Exhaust System Inspection.
(See Special Inspections, Procedures.) ..................................................................
36. Inspect breather tube for obstructions and security ...............................................
37. Inspect crankcase for cracks, leaks, and security of seam bolts ............................
38. Inspect engine mounts for condition and security .................................................
39. Inspect engine baffles for condition and security ..................................................
40. Inspect rubber engine shock mounts for deterioration. (Replace as required.)......
41. Inspect firewall seals ..............................................................................................
42. Lubricate alternator idler pulley (if installed); remove front grease seal
and add grease. (Refer to Lubrication Chart, Section II.) ......................................
43. Inspect condition of alternator and starter .............................................................
44. Inspect security of alternator and mounting...........................................................
45. Inspect engine-mounted accessories for condition and security............................
46. Inspect condition and tension of alternator drive belt.
(See Checking Alternator Belt Tension, Section X or Adjustment of
Drive Belt Tension, Section XIII if air conditioning is installed.) .........................
47. If installed, inspect condition of A/C compressor belt and tension.
(See Adjustment of Drive Belt Tension, Section XIII.) .........................................
48. If installed, check A/C compressor oil level. (See Note 8.) ...................................
49. If installed, inspect A/C compressor clutch security and wiring. (See Note 9.) ....
50. If installed, inspect A/C compressor mounting for cracks, corrosion,
and security ............................................................................................................
51. Check fluid in brake reservoir. Fill as required......................................................
52. Inspect and lubricate all engine controls.
(Refer to Lubrication Chart, Section II.)................................................................
53. Install engine cowling ............................................................................................
C. CABIN AND COCKPIT GROUP
1. Inspect cockpit and cabin doors, latches, hinges, and windows, and
aft baggage compartment door, latch, and hinge for damage, operation,
and security ............................................................................................................
2. Inspect windows for scratches, crazing, and condition..........................................
3. Check window and door seals for deterioration, cracks, and voids .......................
4. Inspect upholstery for tears ....................................................................................
5. Inspect seats and attaching brackets and hardware for condition, security,
and operation. (See Note 20.) ................................................................................
6. Inspect seat belts and shoulder harnesses per Section XIII, Restraint System ......
03/27/08
4C19
Inspection
Interval (Hrs)
50 100
O
O
O O
O
O
O
O
O
O
O
O
O
O
O
O
O
O
O
O
O O
O
O O
O
O
O
O
O
O
III - INSPECTION