Invacare Perfecto 2 SeriesIRC5PO2AW Service Manual page 43

1. Clean loose dirt from outside of compressor.
2. Use the T-25 Torx wrench to loosen and remove the (8) head screws from compressor
head.
3. Remove compressor head and head seal o-rings.
4. Remove both valve plates and valve plate o-rings.
5. Using two flat head screw drivers, remove fan from motor shaft by gently prying
under the center housing.
DO NOT pry under the fan blades, otherwise damage may occur.
Part No 1154245
FIGURE 7.8 Compressor and Compressor Heads
CAUTION
SECTION 7—COMPRESSOR
Head Screws
Compressor Head
Head Seal O-ring
Fan
43
(not shown)
Valve Plate
Valve Plate O-ring
Compressor
Perfecto ™
2