Warming Up The Engine; Forward, Reverse, And Acceleration - TOHATSU MFS 40A Owner's Manual

40
ENGINE OPERATION
all parts of the engine. Operating the
engine without warm up shortens the
engine's life.
ENOM00044-0
Engine speeds
Idling speed after warming up.
Remark: In case of cold engine starting,
idling speed is increased about 400 rpm
7
for several minutes.
Clutch in (In gear)
850 rpm
ENOM00 -0
Trolling engine speed control
function
If the main switch key is pressed for 1 (one)
second during idling or trolling operation,
engine revolution change.
Each time the main switch key is pressed
in the above manner, engine speed
changes as follows.
ENOF00868-0
Clutch off (Out of gear)
850 rpm
ON
1
seconds
ENOF00876-0
Starting
850rpm 750rpm
950rpm 850rpm
Buzzer short sounded one time, when set
to 650 rpm engine speed, and tells the
lowest engine speed was set.
Buzzer short sounded twice, when set to
950 rpm engine speed, and tells the high-
est engine speed was set.
Reset the engine speed when after engine
restarted and or engine speed is above
3,000 rpm, and then trolling engine speed
to be 850 rpm as standard.
In addition, this function does not operate
when battery voltage is lower than speci-
fied, set engine idle and trolling engine
speed to 850 rpm automatically.
ENOM00046-A
4. Forward, reverse, and
acceleration
ENOW00037-0
WARNING
Before shifting into forward or reverse,
make sure that boat is properly moored
and outboard motor can be steered fully to
the right and left. Make sure that no swim-
mer(s) is ahead or astern of the boat.
ENOW00038-A
WARNING
Attach other end of emergency stop
switch lanyard to the operator's PFD
(Personal Flotation device) or arm and
keep it attached during cruising.
650rpm
750rpm