TOHATSU MFS 40A Owner's Manual page 32

32
PRE-OPERATING PREPARATIONS
Remedy
1.
Reduce the throttle to less than half
opening, and move to safe place
quickly, and stop the engine.
Check the propeller for bent or dam-
aged blades.
Consult an authorized dealer if engine
shows the same result even after
replacing propeller with new one.
2.
Move to safe place quickly, and stop
the engine.
Check the engine oil level, and add
engine oil if necessary.
Consult your dealer if the engine oil
level is too low or too high.
6
3.
Move to safe place quickly, and check
the discharge of cooling water from the
water check port at idle speed and
stop engine.
Remove any foreign matter on the gear
case and propeller if necessary. Con-
sult an authorized dealer if no dis-
charge of cooling water.
4. Charge or replace the battery.
5.
Consult an authorized dealer.
6.
Replace the engine oil (See page 68)
and reset the indicator (See page 32).
ENOW00025-A
Low speed ESG ON: Engine speed will
be limited to 2800 rpm, however you
should not continue to run engine.
High speed ESG ON: Engine speed will
be limited to 6200 rpm and engine will
run rough until throttle is reduced.
CAUTION
ENOM00870-0
Engine oil replacement indicator
function reset method
As for "Engine oil replacement indicator
function", informing the appropriate timing
of engine oil replacement by blinking of the
lamp, when beyond 100 hours operating.
1. Be certain the safety lanyard is
installed. Turn the key to the 'on' posi-
tion and after the 'beep' pull the safety
lanyard off.
2. Within 5-10 seconds, Pull the red knob
on the safety switch out and release.
3. Wait 5-10 seconds and pull the red
knob out and release.
1 Second
ENOF00853-0
ENOF00854-0
ENOF00854-0