Table of Contents
Advertisement
User's Manual
Change the numbers by highlighting them and using the Up and Down arrow buttons to increase or decrease
the number. The factory default LAN settings are:
IP Address:
Gateway:
Subnet Mask:
Highlight the box beside DNS Server. Press the Up and Down arrow buttons to set the IP address of the
DNS server.
Highlight the Port Number Setup... box and press the
NOTE: You will need to get the appropriate Port Numbers for each DX-PC For View and WebGuard
related program (Admin, Callback, Watch and Search) from your network administrator.
NOTE: Do NOT use the same port number for two different programs, otherwise, the DVR cannot be
connected with the PC running DX-PC For View or WebGuard.
CAUTION: When changing the port settings, you must change the port settings on the PC
running DX-PC For View or WebGuard as well. Refer to the DX-PC For View manual for
details.
Selecting DHCP from the Type and highlighting
Save button reads the current IP address of the DVR
configured by DHCP (Dynamic Host Configuration
Protocol) network.
Selecting ADSL (with PPPoE) allows you to set up
the ADSL network.
Highlight the box beside ID and press the
A virtual keyboard appears allowing you to enter the
ID for ADSL connection.
Highlight the box beside Password and press the
button. A virtual keyboard appears allowing you to
enter the password for ADSL connection.
NOTE: Entering the ID and Password and
highlighting OK reads the current IP address of
the DVR configured by the ADSL network.
32
192.168.1.129
192.168.1.254
255.255.255.0
Change the numbers by highlighting them and using the Up and Down
arrow buttons to increase or decrease the number. The factory default
Port settings are:
Remote Admin:
Remote Callback:
Remote Watch:
Remote Search:
Remote Audio:
button.
button. The Port Number Setup screen appears.
8200
8201
8016
10019
8116
Advertisement
Table of Contents
