Table of Contents
Advertisement
You can use a mouse for convenient PTZ control. Position the mouse pointer at the bottom of the screen,
and the following PTZ toolbar will display.
Clicking
on the left side exits the toolbar. If you want to display the toolbar again, position the mouse
pointer at the bottom of the screen. Change the toolbar location by clicking the empty space on the left side
of the toolbar and drag it to where you want it located on the screen. Use the arrow buttons on the toolbar
to pan or tilt the camera in the direction you want.
ZOOM MODE
You can enlarge an area of the video by pressing the
after pressing the
Zoom
enlarged. You can move the rectangle around using the arrow buttons. Pressing the
in the Zoom mode enlarges the area in rectangle. Exit the Zoom mode by pressing the
in the Zoom mode, the icon
SPOT MONITORING
You can select the camera you want to display on a Spot Monitor. Press and hold the
front panel for three seconds or longer displays the Sequence Menu.
Select the camera to be displayed on the Spot Monitor. Selecting Sequence from the menu
displays more than one camera on a Spot Monitor sequentially. Select Sequence again
to stop sequencing on the Spot Monitor. Any cameras that are Off, have lost video or are
set to Covert (unless the user has authority to view covert cameras) will be excluded from
the sequence. When the Spot Monitor is in the sequence mode, you can set the camera's
display dwell time. Refer to Chapter 3 – Configuration – Display Setup section for details.
ACTIVE CAMEO MODE
You can enter the Active Cameo mode by pressing and holding the
longer in any multi-view format. The yellow outline surrounding the video indicates the active cameo,
and pressing the arrow buttons moves the active cameo. Pressing the
Cameo mode. Selecting Exit Group Edit in the cameo menu displayed when pressing the
also exits the Active Cameo mode. The active cameo mode will remains in effect for 15 seconds if there
is no further operation.
In active cameo mode, press the button for the camera you want to display in the active cameo. After setting
the camera number to active cameo, the DVR moves the active cameo to the next cameo. When the camera
number exists on the current screen, the active cameo is changed with the existing camera number. When
the camera number does not exist on the current screen, the active cameo is replaced by the camera number.
You can change the screen layout in this way.
Zoom In / Out
Iris Open / Close
button, a rectangle displays on the screen. A rectangle shows the area that will be
displays if Zoom is selected in the Display setup screen (OSD tab).
Focus Near / Far
Set / Load Preset
Zoom
button on the front panel. For a few seconds
Cameo
(Play/Pause) button exits the Active
Digital Video Recorder
(Play/Pause) button
button. While
Zoom
button on the
Spot
button for three seconds or
Cameo
button
49
Advertisement
Table of Contents
