The NETWORK LED is lit when the unit is connected to a network via Ethernet.
The COPY LED is lit when the DVR is clip-copying.
Camera Buttons (1 to 16)
Pressing the individual camera buttons will cause the selected camera to display full screen. Buttons 1 to
9 are also used to enter passwords.
In the PTZ mode, pressing the button 1 zooms in the screen and the button 2 zooms out the screen, pressing
the button 3 focuses near and button 4 focuses far, and pressing the button 5 moves to the preset and button
6 saves the preset.
button toggles between different display formats. The available formats are: PIP,
2x2, 3x3 and 4x4.
Pressing and holding the button for three seconds or longer allows you to select which cameras will display
on the Spot monitor.
When in the live mode, pressing the
button changes the screen from the current camera
group to the next camera group, and the screen displays the page number.
Pressing and holding the button for three seconds or longer displays live channels sequentially.
In the live monitoring mode, pressing the
button enters the PTZ mode, and pressing the button
again exits the PTZ mode and enters the zoom mode. When in the zoom mode, pressing the button again
exits the zoom mode.
NOTE: Pressing the
button enters the zoom mode directly if there is no PTZ camera you
set up in the Camera setup.
When in the PTZ mode, pressing the arrow buttons or
button allows you to control properly
When in the zoom mode, a rectangle displays on the screen. A rectangle shows the area that will be enlarged.
You can move the rectangle around using the arrow buttons. Pressing the
(Play/Pause) button enlarges
the area in rectangle.
button enters the playback mode, and pressing the button again exits the playback
mode. When entering the playback mode, video is paused. Pressing the
(Play/Pause) button plays back
video at regular speed. The screen displays when the DVR is in the Pause mode and the screen displays
when the DVR is playing back video.