ADJ INNO POCKET Z4 User Instructions page 12

Inno Pocket Z4
System Menu: When making adjustments press ENTER to
confirm your setup then press and hold the MENU button
for at least 3 seconds. To exit without making any adjust-
ments press the MENU button. The display will lock after 30
seconds, press the MENU button for 3 seconds to unlock.
ADDR -
DMX Address Setting.
1. Press the either the MENU, UP, or DOWN buttons until
"ADDR" is displayed, press ENTER.
2. The current address will now be displayed and flashing.
Press the UP or DOWN buttons to find your desired address.
Press ENTER to set your desired DMX address.
CHND -
This will let select your desired DMX channel
mode.
1. Press the either the MENU button until "CHND" is displayed,
press ENTER. The current DMX channel mode will be dis-
played.
2. Press the UP or DOWN buttons to find your desired DMX
channel mode and press ENTER to confim and exit.
SLND -
This will let you set unit as a master or slave in a
master/slave configuration.
1. Press the MENU button until "SLND" is displayed, press
ENTER. Either "MAST", "SL 1", or "SL 2" will be displayed.
2. Press the UP or DOWN buttons until your desired setting is
displayed, press ENTER to confim.
NOTE: In a Master/Slave configuration you can set one fixture
to Master and then set the next fixture to "SL 2", the fixtures
will now have contrast movement to each other.
ADJ Products, LLC - www.adj.com - Inno Pocket Z4 Instruction Manual Page 11
System Menu
Inno Pocket Z4
The ADJ UC IR (sold separately) infrared remote gives you con-
trol of various functions (See below). To control the fixture you must
aim the remote at the front of the fixture and be no more then 30 feet
away.
STAND BY - Pressing this button will blackout the fixture.
FULL ON - Hold this button down to fully light up the unit. When you
let the button go, the unit will return to its previous state.
FADE/GOBO - Press this button to activate Fade mode.
"DIMMER +" and "DIMMER -" - Use these buttons to adjust the out-
put intensity in Color mode.
STROBE - This button will activate the strobe effect. Press and hold
this button to activate strobing and release the button to stop strob-
ing.
COLOR - Press this button to enter Dimmer mode. Use the 1-9 but-
tons to select your desired color. Adjust the output intensity using the
"DIMMER +" and "DIMMER -" buttons.
1-9 - In color mode, these buttons will allow you to select a desired
color. In show mode, these buttons will allow you to select a desired
show.
SOUND ON & OFF - These buttons activate and deactivate the
sound active mode.
SHOW - This activates the show mode. Use buttons 1-4 to select
your desired show.
ADJ Products, LLC - www.adj.com - Inno Pocket Z4 Instruction Manual Page 20
UC IR Operation