Table of Contents
Advertisement
NX-4 Control
LOC
PG
37
17
SIREN AND SYSTEM SUPERVISION
Segment #1 (Circle numbers to program)
1
Reserved.
2
Reserved.
3
Siren blast at arming.
4
Siren blast at exit delay expiration.
5
Siren blast at closing kissoff.
6
Siren sounds during a cross zone verification time.
7
Siren sounds for a tamper.
8
Siren blast one time for wireless arming, two times for wireless disarming.
for SIA CP-01 installations.)
Segment #2 (Circle numbers to program)
1
Convert siren driver to voltage out.
2
Siren sounds for expander trouble (required for U.L.).
3
Immediate Restore by Zone.
4
Dynamic battery test performed upon arming.
5
Battery missing test performed every 12 seconds.
6
Manual bell test performed during [r]-[4] test function.
7
Manual communicator test performed during [r]-[4] test function.
8
Box tamper enabled.
Segment #3 (Circle numbers to program)
1
Box Tamper report enabled.
2
AC Fail report enabled.
3
Low Battery report enabled.
4
Auxiliary power over current report enabled.
5
Siren supervision report enabled.
6
Reserved.
7
Reserved.
8
Expander trouble report enabled.
Segment #4 (Circle numbers to program)
1
Failure To Communicate report enabled.
2
Log Full report enabled.
3
Autotest report enabled.
4
Start and End Programming report enabled.
5
End Download report enabled.
6
Sensor Low Battery report enabled.
7
Sensor Missing report enabled.
8
Reserved.
Segment #5 (Circle numbers to program)
1
Lost Clock service LED enable.
2
Zone Doubling enable. (Requires additional devices, see page 7)
3
Disable on-board four zones.
4
Enables two trips on the same cross-zone to activate the alarm.
5
Disables bypass reports for force armed zones
6
Reserved.
7
Clock uses internal crystal.
8
Disable Temporal Siren on Fire. (Do NOT disable for UL installations.)
38
18
SWINGER SHUTDOWN COUNT
Page 28
DESCRIPTION
DEFAULT
1
DATA
(Note: Must be disabled
_
Hide quick links:
Advertisement
Table of Contents
