Adjusting Vertical Airflow Direction; Vertical Airflow Adjustment - Mitsubishi Electric 2.5KKC Operation Manual

A B
CENTRALLY CONTROLLED
CHECK
˚C
STAND BY
DEFROST
CLOCK ON OFF
TEMP. TIMER SET
REMOTE CONTROLLER
PAR-JH240KA
30˚
C
70˚
14
C D E
F
ON/OFF –
1Hr.
FILTER
˚C
CHECK MODE
TEST RUN
NOT AVAILABLE
FILTER
CHECK
TEST RUN
1
A
B
4. Operation
E

4.10. Adjusting vertical airflow direction

The vertical air vane helps select the vertical direction of the airflow.
1 Press button to select the vertical airflow direction.
• Each time you press the button, the option changes are displayed on
the remote controller, as shown below.
→
A Swing
↓
B Horizontal airflow 30°
↓
C Downward airflow at an angle of 45°
↓
D Downward airflow at an angle of 55°
↓
E Downward airflow at an angle of 70°
• Immediately after the power-on sequence, the unit is automatically
provided with the initial settings listed below.
In the cooling/drying modes: Horizontal airflow
In the heating mode:
• When you have selected gentle or cooling mode, or you have entered
the drying mode,the available options change in the following order :
A→B→D→E→A
One hour after you have selected D or E, the airflow automatically
•
changes to A and the display F "1HR" appears.
Do not use D or E too often with the Low airflow option in the cooling
•
and drying modes or condensation can occur.

4.11. Vertical airflow adjustment

Setting this to "Swing" moves the automated vane back and forth within
the swing range, so that the air is directed upwards and downwards.
In the SWING mode, the remote controller displays a moving arrow as
shown in the diagram to indicate the swinging automated vane.
The arrow motion on the remote controller display and the actual auto-
mated vane movement do not match with each other.
In the COOL or FAN mode operation, the vane is set in the 'fluctuating'
mode, varying airflow rate automatically.
When you set OFF the LOUVER switch, the automated vane will return to
the position before the SWING mode has been selected.
When you toggle the MODE SELECT buttons between COOL, DRY and
FAN with the LOUVER switch set OFF, the airflow is set to approx. 30
degrees-horizontal blowing in the COOL or electronics DRY mode while
to approx. 70 degrees-downward blowing in the FAN mode.
A Horizontal air outlet
B Downward air outlet
C Swing range <30 degrees to 70 degrees>
Downward airflow (70°)