Installing Three Units Side By Side - AGA marvel M60CFWR-SS Installation, Operation And Maintenance Instructions

INSTALLING THE THREE UNITS SIDE BY SIDE BY SIDE
Installing Three Units Side-By-Side By Side:
When three (3) units are installed together, a divider panel
needs to be installed between two (2) adjacent power
modules (refer to Figure 16). The divider panel is fastened
to the freezer right side at the top of the cabinet and and
another divider to the wine cellar right side. Remove the
two screws holding the divider panel in place, flip over so
the divider is above the cabinet and secure with the two
removed screws.
NOTE
If the divider panel is not installed, the warm discharge air
from the refrigerator module will be drawn into the intake of
the freezer module causing the freezer module to not oper-
ate properly.
Divider
panel
Figure 16
A
A
Securing the trim:
Install a wood shim (provided) cut to the dimensions shown
in Section A-A to the side trim of the first cabinet to be
installed in the rough in opening. After installing the second
cabinet drill and install screws into the wood shim for the
second cabinet. Repeat for third cabinet.
Drill three (3) holes
each side equal
distance apart in
vertical section of
aluminum frame
and install screws
as shown.
Section A-A
U-shaped
mullion cover
Mounting U-shaped mullion cover:
Remove paper backing from tape on inside of mullion cover
(3) places. Press U shaped mullion cover over cabinet trim
at center of cabinet as shown.
14
Wood Shim
⁄ " x ⁄ " x 68"
7 7
8 8
(22.4mm x 22.4mm
x 165.1cm)
⁄ "
7
8
(22.4mm)
⁄ "
7
8
(22.4mm)
-Cabinet trim-
Tape, (3) places
along length of
cover