Wiring Instructions; Remote Controls - Majestic fireplaces NVC36 Installation And Homeowners Operating Instructions

Majestic Fireplaces

Remote Controls

Optional remote control units are available to control
different functions of the appliance.
Model Function(s) Controlled
MRC1 ON/OFF
MRC2 ON/OFF and Temperature
MRC3 ON/OFF and Temperature control
with a digital and a programmable
24 hour clock
IMT Wall mounted thermostat control
Ceramic Refractory Panels
Ceramic refractory panels are available to line the
firebox area.
Unit
NVC36
NVC39
NVC43
Take care when handling the refractory panels as they
are fragile until held in place and supported.
Installation, refer to Figures 24 & 25
1. Remove the window frame assembly.
2. Remove the logs.
3. Place the lower supports for the side refractory
panels on the base of the firebox. Place each
support so that the slotted hole fits over the forward
screw head along the edge of the base.
4. Lay the angular base panels in place on the floor of
the firebox on either side of the burner housing
assembly.
5. Loosely attach the top adjustable tabs to the studs
located in the top of the firebox toward the front
corners.
6. Place the rear refractory panel in place. Locate the
'small brick' edge of the panel into the two small
supports on the back panel just above the rear log
support.
7. Slide the side refractory panels into place to hold the
rear panel secure. Adjust the top adjustable tabs to
hold the side panel against the firebox wall and
secure the tab. Repeat the procedure on the other
side.
8. Replace the logs and window frame assembly.
For aesthetic purposes we recommend lining up the
horizontal mortar lines.
22
NVC Series B-Vent
®
Kit Model
NV36CR
NV39CR
NV43CR
Adjustable
Tab
Side
Panel
Floor
Refractory
Panel
Lower Side Supports
Fig. 24 Install ceramic refractory panels.
Rear
Refractory
Panel
Rear Panel
Support
Brackets
Rear Log Support
Fig. 25 Place the rear panel on rear support brackets.
Arched Door Front
The arched door front kit is designed to visually en-
hance the appearance of the NVC fireplace.
To install the door front simply position the magnets as
shown in Figure 26. Place the arched door into position
and peel off the plastic. (Fig. 27)
Magnets
Fig. 26 Install magnets.
Adjustable
Tab
Side
Panel
Floor
Refractory
Panel
FP1193
Firebox
Back
FP1194
FP1195
20000194