Replacing The Mains Supply Cable; My Appliance Isn T Working Correctly - Baumatic BWHC605 User Manual

Replacing the mains supply cable

If the mains supply cable is damaged, then it must be replaced by an
appropriate replacement.
The mains supply cable should be replaced in accordance with the
following instructions:
o Switch the appliance off at the control switch.
o Open the terminal block on the underside of the hob.
o Unscrew the terminal screws fixing the cable.
o Replace the cable with one of the same length and in accordance
with the specification given on page 22.
o The green-yellow earth wire must be connected to the terminal
marked . It must be about 10 mm longer than the live and
neutral wires.
o The blue neutral wire must be connected to the terminal
marked with letter (N) - the live wire must be connected to the
terminal marked with letter (L).

My appliance isn t working correctly

o The cooking zones are not functioning or will not switch
on.
* It has been more than 2 minutes since the appliance was
switched on.
using the ON/OFF button and then switch on a cooking zone.
* The safety lock has been switched on (see the Locking the hob
top section for information on how to turn off the safety lock).
* Several cooking zone selection buttons have been pressed at
once. You should only try to switch on one cooking zone at once.
* The safety cut out has been triggered. Press the ON/OFF button
to reset the hob.
* Check that the mains electrical supply to the appliance is correct
and working. Check the mains fuse.
You should switch the appliance back on again,
23