Troubleshooting; Power Indicator Is Not Illuminated; Fuse Replacement; No Sound - Rotel ra-1570 Owner's Manual

14
• OPT2 VOL: VARIABLE (disabled) is factory default.
• PC‑USB VOL: VARIABLE (disabled) is factory default.
• BLUETOOTH VOL: VARIABLE (disabled) is factory default.
NOTE: The Volume knob on the front panel and Volume +/‑
the IR remote are disabled when the volume is Fixed. To disable this
feature set the Fixed Volume level to "Variable".
• PC‑USB AUDIO CLASS: Change supported PC‑USB Audio Class of the
attached device.
NOTE: Some computers attached to the PC‑USB do not support USB
Audio Class 2.0 and do not support 24/192 audio playback. If needed
the PC‑USB can be configured for USB Audio Class 1.0. Please consult
your computer operating system for details.
• SOFTWARE VERSION : This shows the current software version loaded
into the amplifier.
• FACTORY DEFAULT: This sets the unit back to the original state as when
it left the factory. Press the + button on the front panel or RIGHT arrow key
on the remote control to select <YES> then press the "ENTER" button on the
front panel or "ENT" key on the remote control.
NOTE: All previously configured options will be erased and reset to
the factory default settings.

Troubleshooting

Most difficulties in audio systems are the result of incorrect connections,
or improper control settings. If you encounter problems, isolate the area
of the difficulty, check the control settings, determine the cause of the fault
and make the necessary changes. If you are unable to get sound from the
RA‑1570, refer to the suggestions for the following conditions:

Power Indicator Is Not Illuminated

The Power Indicator ring around the power button and the basic items in the
Display window should be illuminated whenever the RA‑1570 is plugged
into the wall power outlet and the POWER switch is pushed in. If it does not
light, test the power outlet with another electrical device, such as a lamp.
Be sure the power outlet being used is not controlled by a switch that has
been turned off.

Fuse Replacement

If another electrical device works when plugged into the power outlet, but
the Power Indicator still will not light when the RA‑1570 is plugged into
the wall outlet, it indicates that the internal power fuse may have blown.
If you believe this has happened, contact your authorized Rotel dealer to
get the fuse replaced.

No Sound

Check the signal source to see if it is functioning properly. Make sure the
cables from the signal source to the RA‑1570 inputs are connected properly.
Check the wiring between the RA‑1570 and the speakers.

Cannot Connect via Bluetooth

s on
button If you cannot pair your Bluetooth enabled device to the RA‑1570, delete the
memory of the previous connection on the RA‑1570 and on your device. On
your device this is often listed as "Forget this Device". On the RA‑1570 IR
remote PRESS and HOLD the STOP
display shown "Reset BT DB List?" then release the button. Select <Yes>
and press "ENT". Then try to make the connection again.

Playable Audio Format

USB Apple (iPhone, iPod, iPad)
Format
Any supported file loaded
to Apple device.
USB Bluetooth
Format
Any format supported
by the sending device.
USB Flash Drive
Format
MP3
WMA
WAV
OGG Vorbis
PC-USB
Format
Format determined by
the Media Player/
Server software that
you use.
Coax/Optical
Format
SPDIF LPCM
RA‑1570 Stereo Integrated Amplifier
button for 5 seconds until the front
M
Notes
Phone may resample depending on stored
format. May exclude Apps designed to play
formats not originally supported by the sending
device.
Notes
May exclude Apps designed to play formats not
originally supported by the sending device.
Notes
48kHz, 16 Bit (Maximum)
Notes
Any supported format by the PC software:
44.1kHz, 48kHz, 88.2kHz, 96kHz, 176.4kHz, 192kHz
16 Bit, 24 Bit
Notes
44.1kHz, 48kHz, 88.2kHz, 96kHz, 176.4kHz, 192kHz
16 Bit, 24 Bit