Electrical Connection - Miele CM6110 Operating Instructions Manual

Before connecting the appliance to the
mains supply, make sure that the
connection data on the data plate
corresponds to the voltage and
frequency of the household supply. This
data must correspond in order to avoid
the risk of damage to the appliance.
Consult a qualified electrician if in any
doubt.
The data plate is located behind the
drip tray. This can be seen on the left-
hand side when the drip tray is pulled
out.
The machine is supplied with a mains
cable with moulded plug for connection
to a 50 Hz 220–240 V supply.
The coffee machine must be connected
to the mains supply via a suitable
switched socket with earthing contact.
The fuse rating must be at least 10 A.
The socket should be next to the
appliance and easily accessible.
Do not connect the machine to the
mains electricity supply by a multi-
socket adapter or an extension lead.
These do not guarantee the safety of
the appliance (e.g. danger of
overheating).
Do not connect the machine to an
inverter such as those used with an
autonomous energy source e.g. Solar
power. When switched on, peak loads
in the system can cause the safety
switch off mechanism to be triggered.
This can damage the electronic unit.

Electrical connection

The machine must not be used with so-
called energy saving plugs either.
These reduce the amount of energy
supplied to the machine causing it to
overheat.
If the connection cable is faulty, it may
only be replaced by a qualified
electrician in order to avoid a hazard.
Useful tip: If the connection cable is
too long, push it up through the
opening at the back of the machine.
77