Miele CM6110 Operating Instructions Manual page 69

Problem
Empty the drip tray and the
appears
waste container
in the display, even
though the drip tray is
empty.
Insert the drip tray and the
waste container appears
in the display even
though both are fitted.
The drip tray or waste
container is full or
overflowing, although
they have been emptied
following each
reminder.
Fill the bean container
appears in the display
even though the bean
container has just been
filled.
The coffee machine
does not rinse itself
when turned on.
Possible cause and remedy
The drip tray isn't sitting correctly in the appliance.
 Push the drip tray all the way into the appliance.
 Make sure that the lower panel is sitting on the
drip tray correctly.
The drip tray is not correctly fitted and is therefore not
detected.
 Empty the drip tray and the waster container.
Reassemble all parts and place the drip tray and
the waste container back in the coffee machine.
The service door is open.
 Close the service door.
 If necessary, empty the drip tray and the waster
container. Reassemble all parts and place the drip
tray and the waste container back in the coffee
machine.
This is not a fault.
The drip tray and waster container were probably
removed or the service panel was opened without the
drip tray and waste container being emptied. When
the drip tray is removed or the service panel opened,
the internal counter for emptying the drip tray and
waste container is automatically reset.
 Remove the drip tray and waste container from the
machine and empty them.
This is not a fault.
 Confirm the message with OK.
This is not a fault.
If the coffee machine still has an operating
temperature higher than 60 °C, rinsing will not take
place.
Problem solving guide
69