Where To Place The Device; Supplying Ac Power To The Device - Philips DreamStation CPAP User Manual

Where to Place the Device

Place the device on a firm, flat surface somewhere within easy reach of where you will use it at a level lower than
your sleeping position. Make sure the device is away from any heating or cooling equipment (e.g., forced air vents,
radiators, air conditioners).
Note: When positioning the device, make sure that the power cable is accessible because removing power is the
only way to turn off the device.
Caution: Make sure the filter area on the side of the device is not blocked by bedding, curtains, or other items.
Air must flow freely around the device for the system to work properly.
Caution: Do not place the device directly onto carpet, fabric, or other flammable materials.
Caution: Do not place the device in or on any container that can collect or hold water.

Supplying AC Power to the Device

Complete the following steps to operate the device using AC power:
1. Plug the socket end of the AC power cord (included) into the power supply (also included).
2. Plug the pronged end of the AC power cord into an electrical outlet that is not controlled by a wall switch.
Note: Example only shown here. Local electrical outlet and power cord may vary.
3. Plug the power supply cord's connector into the power inlet on the side of the device.
4. Verify that the plug at the side of the device, at the power supply, and at the electrical outlet are fully inserted. This
will help to ensure that a secure, reliable electrical connection has been made.
Note: If the following Incorrect Power Supply icon appears on the screen, please repeat step 4.
Important: To remove AC power, disconnect the power supply cord from the electrical outlet.
Warning: Periodically inspect electrical cords and cables for damage or signs of wear. Discontinue use and replace
if damaged.
Caution: Do not use extension cords with this device.
6 User Manual