Device Alerts - Philips DreamStation CPAP User Manual

Device Alerts

Device alerts are pop-ups that show up on the UI screen. There are 5 types of alerts described here:
• Status: These alerts are just the pop-up screen.
• Notification: These alerts consist of the pop-up screen in addition to a blinking Power LED on top of the device.
• Alert 1: These alerts consist of the pop-up screen, a blinking Power LED and an audible beep when displayed. This
alert will not occur during therapy.
• Alert 2: These alerts consist of the pop-up screen, a blinking Power LED and an audible beep when displayed. This
alert can occur during therapy.
• Safe State: These alerts consist of the pop-up screen, a blinking Power LED and a repeating audible beep.
Note: Status alerts automatically time out after 30 seconds and their pop up screens disappear. All other alerts
must be acknowledged to clear.
Alert Summary Table: The following table summarizes the alerts.
Alert Icon
Data Activity: Do
not remove SD
card.
Change Accepted
EZ-Start
Pressure
Incremented to
xx.x
Oximetry: Good
Connection
(icon only)
Pair?: 123456
Yes/No
16
Type Description
Status SD card read/write
underway.
Status Confirms acceptance
of prescription change
or device upgrade.
Status Displays when
EZ-Start mode is
enabled and device
is increasing therapy
pressure setting for
the next session.
Status Displays on the
therapy screen when
the blower is on
and 3 seconds of
good connection is
detected. Appears
at the beginning of
therapy. This screen
will not display
again if the finger
probe is removed
and reapplied unless
therapy is stopped
and restarted.
Status Prompts to accept or
decline pairing to a
Bluetooth compatible
device. This device
can be identified by
the digits displayed.
Possible Cause
n/a
n/a
n/a
n/a
n/a
Action
No action needed.
No action needed.
No action needed.
No action needed.
Rotate control dial to
accept pairing (Yes),
or decline (No), then
press control dial to
confirm selection.
User Manual