Table of Contents
Advertisement
Changing factory-set options
Option Adjustment
Mode
AUTO WATER LEVEL
Less Water
After using your washer you may
want to change some of the factory-
set options to suit your wash needs.
You can change the following
factory-set options:
• The rinse option on HEAVY DUTY,
REGULAR and WOOL cycles.
• The amount of water used in the
Water Saver option.
• The temperature for each wash
temperature setting.
• The number of beeps at the end of
the cycle.
• The Out of Balance Recovery routine.
• The fill level selected by Auto
WATER LEVEL.
To make these changes it is
necessary to enter the Option
Adjustment Mode.
Colder
More Water
AUTOMATIC
OUT OF BALANCE
RECOVERY
Definition of pads in the Option Adjustment Mode
To enter Option Adjustment Mode:
1 Press START/PAUSE and hold
2 When the pads have been
3 Use the pads on the panel to make
4 Press POWER to return to nor-
5 Your washer will automatically
6 To make further changes, repeat
TEMPERATURE SETTING ADJUSTMENT
15 Beeps
5 Beeps
None
BEEPS
down. Press POWER.
pressed correctly the machine
will give two quick beeps and
show an unusual pattern of lights.
In this mode the lights are used
to indicate the different options
available. The below diagram
shows how the lights relate to the
options you can change.
your changes to the factory-set
options.
mal mode and store your
changes.
remember your changes even
when electricity has been turned
off.
the above steps .
Hotter
Hot
More
2 Deep
Warm
Standard
1 Deep
Cold
Less
Spray & Deep
RINSES
TEMP
SHOWER
SETTING
RINSE
VOLUME
ADVANCE
POWER
START/
PAUSE
DELAY
START
17
Advertisement
Table of Contents
