Service Mode - GE Profile PDW8200 Series Technical Service Manual

Status Indicator Lights What It Means
START/RESET Cycle has been interrupted by pressing the START/RESET keypad. Light will quit
flashing after the dishwasher automatically drains out the water.
CLEAN Unit has no water. Check the water supply . If water is turned on call for service.
THIS DISHWASHER IS PROGRAMMED WITH A SERVICE MODE TO AID THE TECHNICIAN IN TROUBLESHOOTING THE DISH-
WASHER. EACH COMPONENT MAY BE CYCLED TO DETECT IF IT IS FUNCTIONING CORRECTLY. COMPONENTS ARE CYCLED BY
PRESSING KEYPADS TO THE RIGHT OR LEFT OF THE START/RESET KEYPAD. DETERMINE WHICH TYPE OF CONTROL PANEL IS
PRESENT (FLAT OR BOWED) AND THEN USE THE MATRIX BELOW TO DETERMINE HOW CYCLE EACH COMPONENT.
FLAT PANEL
5L 4L
3L 2L 1L
Indicates Keypad Used Only on Some Models
TO ENTER SERVICE MODE:
PRESS THE COOKWARE (POTS & PANS ON SOME
MODELS) AND THE HEATED DRY KEYPAD
SIMUTANEOUSLY FOR 3 SECONDS.
TRITON MONARCH SERVICE MODE TEST MATRIX *
KEYPAD
CONTRO
PAD
TYPE
Keypads to the left of the Start/Reset keypad (Selections)
FLA
1L
BOWE
FLA
2L
BOWE
FLA T
3L
BOWE
FLA T
4L
BOWE
FLA
5L
BOWED
ST ART/RESET
Keypads to the right of the Start/Reset keypad (Enhancement/Extras)
1R FLAT
BOWED
FLAT
2R
BOWED
FLAT
3R
BOWED

Service Mode

FLASHING DISPLAY LIGHTS
ST ART
1R 2R 3R 4R
RESET
L DESCRIPTION
T Activates Drain Pump
D Activates Detergent Module
T Activates Detergent Module
D Activates Main Pump
Activates Main Pump
D Activates Heating Element
Activates Heating Element
D Activates Drain Pump
T Activates Water Valve
(Length of time is model dependent)
Used to EXIT Service Mode
Activates the following in order:
Status LEDs; Wash LEDs;
Start/Reset and Option LEDs;
finally "888" will be shown
on the 3 digit display
(some models)
Opens Active Vent
Closes Active Vent
5L
4L
Indicates Keypad Used Only on Some Models
TO EXIT SERVICE MODE :
PRESS THE START/RESTART KEYPAD AT ANYTIME
TO EXIT.
TIME in seconds**
75
60
75
300
50 or 71
3 seconds each cycle
– 28 –
BOWED PANEL
1R 2R 3R 4R
3L START
2L 1L
RESET
*NOTE : Service mode may
be used for 30 minutes
maximum. After 30 minutes
the service mode will
automatically turn off.
**NOTE : Component will be
activated for indicated
time. Component may be
deactivated by pressing
the same keypad that was
pressed to activate the
component.