Motorola DS3578 Product Reference Manual page 35

Beeper Definitions (Continued)
Table 2-1
Beeper Sequence
High-high beeps
High-low-high-low beeps
High-low-low beeps
Low beep
Low-high-high beeps
Short low-short high-short low-short high
beeps
ADF Programming Error Indications
Low-high-low-high beeps
Low-high-low beeps
Low-high beeps
Host Specific
USB Only
Four high beeps
Short high-short low (disconnect)
followed by a short low-short high
(reconnect) beep sequence
RS-232 only
High-high-high-low beeps
High beep
Enter another criterion or action, or scan the Save Rule bar code.
Rule saved. Rule entry mode exited.
All criteria or actions cleared for current rule, continue entering
rule.
Delete last saved rule. The current rule is left intact.
All rules have been deleted.
Out of host ADF parameter storage space. See
Parameters on page 5-4.
Out of rule memory. Erase some existing rules, then try to save
rule again. (It is not necessary to re-enter the current rule.)
A DS3578 digital scanner was inserted into an STB3478 cradle.
ADF transmit error. Cancel rule entry. Rule entry mode exited
because of an error or the user asked to exit rule entry.
Entry error, wrong bar code scanned. Re-enter criterion or action.
All previously entered criteria and actions are retained. Criteria or
action list is too long for a rule.
The digital scanner did not complete initialization. Wait several
seconds and scan again.
1. The digital scanner scanned a USB device type. The digital
scanner must establish communication with the bus before it can
operate at the highest power level.
2. The USB bus may cause power to the digital scanner to cycle
on and off more than once. This is normal and usually happens
when the host PC cold boots.
RS-232 receive error.
A <BEL> character is received and Beep on <BEL> is enabled
(Point-to-Point mode only).
Scanning
Indication
Default
2 - 3