This is used to quickly enable or disable the track of the lead established with L L e e a a d d C C h h a a n n n n e e l l in page F F 3 3 T T r r a a n n s s p p o o s s e e r r .

Press the function push button to switch On and Off. If the MIDI channel does not correspond to that of the lead,

there is the risk of disabling a different track such as that of the bass or of another instrument. The F F 8 8 L L e e a a d d status

is valid for all Midi files.

Transposer: This is set in the middle of the

display and points out the transposition value

in semitones entered using the C C U U R R S S O O R R push

buttons (Transposer). This value can be

applied to the Midi file, to just the keyboard, or

to both. Keep in mind that Midi file transposi-

tion can be also modified from the D D i i s s k k ( ( F F 9 9

U U t t i i l l i i t t y y , , F F 3 3 T T r r a a n n s s p p . . ) ) menu where the Midi file is

saved with the new transposition value.

Please refer to the relevant section.

F F 1 1 G G l l o o b b a a l l : : When set to On, the transposition

value is applied to both Midi files and keyboard.

F F 2 2 K K e e y y b b o o a a r r d d : : When set to On, the transposition value is applied only to the keyboard, without altering the

Midi file.

F F 3 3 S S o o n n g g : : When set to On, the transposition value is applied only to the Midi file, without altering the sounds

assigned to the keyboard.

F F 6 6 I I n n t t e e l l l l i i g g e e n n t t T T r r a a n n s s p p o o s s e e r r : : This applies a special transposition to the tracks of the Midi file so that the sin-

gle sounds are always played in their natural range and are re-lead within the original octave. The results

are much more musical than with the simple application of the transposition (which otherwise as an exam-

ple could produce excessive 'high' notes if say a song were transposed 9 semitones up!). It is enabled as a

default setting.

F F 7 7 L L e e a a d d C C h h a a n n n n e e l l : : By selecting a parameter and using the D D A A T T A A C C U U R R S S O O R R push buttons you can modify the

MIDI channel of the Midi file that bears the main lead, which can be muted using the L L e e a a d d O O f f f f function. The

lead is usually set to channel 4.

F F 1 1 0 0 S S a a v v e e T T o o D D i i s s k k : : This is used to save the settings of the transposition for the tracks of the Midi file once

and for all by recording a new Midi file on disk that replaces the previous one. The procedure is done using

S S o o n n g g P P l l a a y y in stopped status. If the Midi file has an audio loop, the S S a a v v e e T T o o D D i i s s k k command modifies the into-

nation of the loop without altering the velocity and the synchronisation with the Tempo.

F7 Go Next: This indicates the next Midi file to be played back or loaded.

F F 8 8 L L e e a a d d : : If set to On, the lead track will be reproduced. If pressed again the track of the Midi file indicated

as Lead Channel will be disabled.

F F 1 1 0 0 L L y y r r i i c c : : If there are Lyric events in the Midi file and if the function is set to On, the display shows the words

set in syllables. In this status, if F F 1 1 0 0 is pressed again, the function will be disabled.

Song Play, Midi file and Karaoke

SD5

Table of Contents