Charging The Battery; Checking The Battery Status - Intermec SR61B User Manual

Charging the Battery

Checking the Battery Status

SR61B Cordless Scanner User's Guide
For more information about the scanner options, see
Codes" on page 8.
The SR61B uses a lithium-ion battery as its main power source. You
need to fully charge the battery before you can use the SR61B.
The battery pack used in this device may ignite, create a chemical
burn hazard, explode, or release toxic materials if mistreated. Do
not incinerate, disassemble, or heat above 100°C (212°F). Charge
only with Intermec Models AC5, AC6, AC7, and AC8 (see
Bay, 4-Bay, or 8-Bay Charger" on page
may cause burns. Keep away from children.
Use only Intermec battery pack Model AB3 (P/N 075082-xxx). Use
of incorrect battery pack may present risk of fire or explosion.
Promptly dispose of used battery pack according to the
instructions.
Make sure you fully charge the battery before you start using the
SR61B.
To charge the battery
Place the SR61B with the battery installed in the desktop/wall
•
mount 1-bay charger (AC5).
Or,
• Remove the battery from the SR61B, and insert the battery into
the 2-bay, 4-bay, or 8-bay (AC6, AC7, or AC8) charger.
For more information, see
The SR61B status light automatically displays a low battery signal
(blinking red) when less than 20% of the battery capacity remains. If
so, you need to charge the battery.
Status light signals are different when the scanner is docked in a
charger. For more information, see
Chapter 1 — Introducing the SR61B Cordless Scanner
13). Do not short circuit;
"Required Accessories" on page
"Status Light" on page
"Scanning Bar
"SR61 2-
12.
6.
3