Intermec SR61B User Manual page 21

SR61B Cordless Scanner User's Guide
If you are using bar code labels that are encoded in a different
symbology, you need to enable the symbology on your SR61B. Use
EasySet version 5.6.5.3 or later to enable and disable symbologies for
your scanner. EasySet is available on the Intermec web site at
www.intermec.com.
Before you can scan bar codes and send data to your data collection
application, you need to establish a Bluetooth connection between
your SR61B and the host device. If your scanner is not connected it
will emit an error beep when scanning bar codes. For more
information about establishing a Bluetooth connection, see
"Connecting the SR61B" on page
To scan a bar code label with an SR61BL or SR61B1D
1 Turn on your scanner by pressing the trigger.
2 Connect your scanner to a Bluetooth device.
3 Point the SR61B at the bar code label and hold the SR61B at a
slight angle 5 to 10 cm (2 to 4 in) from the label.
4 Pull the trigger, and direct the red beam so that it falls across all
bars in the bar code label.
Use this test bar code:
Code 39 Test Bar Code
*123456*
*123456*
Tip: Depending on your screen resolution, you may be able to scan
bar codes displayed on your computer screen except with SR61BL
(laser imager). Print out and scan bar codes with the SR61BL.
When the SR61B successfully reads a bar code label, the SR61B
beeps one time, the status light briefly turns green, and the
scanner beam turns off. If Vibrate Alert is enabled, the SR61B
briefly vibrates.
5 Release the trigger.
Chapter 1 — Introducing the SR61B Cordless Scanner
17.
9