Intermec SR61B User Manual page 54

Chapter 4 — Troubleshooting and Maintaining the SR61B
38
Problems and Possible Solutions (continued)
Problem
You scan a bar code and
the status light turns
on, but the SR61B does
not beep.
You scan a
(configuration) bar code
and the SR61B emits six
very fast beeps.
You scan a bar code, the
SR61B beeps twice, and
the status light blinks
green twice, but the data
is not transmitted to the
host computer.
Possible Solution
The beep duration, volume, frequency, and
number may be configured so the SR61B does not
beep. To reset the SR61B, scan this bar code:
Reset factory defaults
The SR61B does not recognize or support the
configuration bar code you scanned, or has lost
connection with your host (out of range, low
battery, disconnected SD61 Base Station cable...).
Check that the SR61B supports the configuration
bar code and try to re-establish the Bluetooth
connection by:
•
getting back into range, or
•
recharging your scanner, or
•
reconnecting the SD61 Base Station cable to
your host, or
•
following the Bluetooth connection procedure
from start (see "Connecting the SR61B" on
page 17).
Try these possible solutions:
•
Make sure that your data collection application
is set up to receive data from the SR61B.
•
If you are using an SD61 Base Station
connected to your host using an RS-232 cable,
make sure that the serial parameters on the
SR61B match the serial parameters of the host
computer. The default serial parameters for the
SR61B are: 19200 baud, 8 data bits, no parity,
and 1 stop bit.
SR61B Cordless Scanner User's Guide