Pairing As An Spp Bluetooth Device - Intermec SR61B User Manual

Chapter 2 — Connecting the SR61B
24

Pairing as an SPP Bluetooth Device

This section describes how to pair your scanner from your host PC.
To pair as an SPP Bluetooth device
1 Turn on your scanner by pulling the trigger.
2 Scan the Bluetooth device profile - SPP configuration bar code.
Bluetooth Device Profile - SPP (*)
3 Double-click the Bluetooth icon on your taskbar. The Bluetooth
Devices window appears.
4 Click on the command for adding a Bluetooth device (Add or Add
a device depending on operating systems). The wizard for adding
Bluetooth devices appears.
5 Follow the onscreen instructions until your host searches for
Bluetooth devices. The SR61B scanner appears in the Bluetooth
device list in the following format: SR61B - BDA, where BDA is the
scanner's Bluetooth Device Address.
You can find the BDA on the scanner's label.
Note: If the scanner does not appear in the list, it might be already
paired with the host. Under some operating systems, paired devices do
not appear in the Bluetooth device search list.
6 Select your scanner and validate.
7 If a PIN is required (depending on your host operating system and
Bluetooth version), enter the default Bluetooth PIN (0000) and
validate.
Note: A pairing confirmation can be enabled. If so, the blue Intermec
Ready-to-Work indicator starts blinking rapidly at this stage,
indicating that the scanner is awaiting acknowledgement. Pull the
trigger to complete the pairing procedure.
Your scanner is now paired with your host. Two virtual Standard
serial ports over Bluetooth link (incoming and outgoing) are
created.
SR61B Cordless Scanner User's Guide