Cisco SPA 303 Series User Manual page 3

Placing Outbound Calls
You can make outbound calls by simply dialing the destination telephone number. For those who have a
10 digit US/Canada number in addition to 4 digit extension number their selection (pressing) of 'green'
line button next to the extension number will display company's business telephone number to the call
recipient. On the other hand selection (pressing) of 'green' line button next to the 10 digit number will
display that number to the call recipient
Ending a Call
To end a call:
• If you are using the handset, just hang up.
• If you are using the speakerphone, press the Speaker button.
• If you are using a headset, either press the Headset button (wired) or replace the receiver (when using
certain wireless models).
Ignoring an Incoming Call:
• When call lands press 'Ignore' soft-key button.
Transferring a Call
You can perform following types of transfers:
Performing an Attended Transfer
• Attended Transfer:
- transfer the call while the phone is ringing.
- wait for the person to answer before transferring the call.
STEP 1 - During an active call, press 'xfer' soft-key. The call is placed on hold and a new line is opened to
dial the number where the call in intended to be transferred.
STEP 2 Either:
• Enter the number to which you want to transfer the call, then press the 'dial' soft-key or wait a few
seconds.
• Press the 'dir' soft-key and either choose a number from the personal directory or select the
Corporate Directory, then press the 'dial' soft-key.