Front Panel - AKG DMS70 Quattro User Instructions

NOTE
DMS70 Quattro

Front panel

5
6
4
3
2
1
Figure 1: Front panel controls on the DSR70 receiver
The controls (2 and 3) and the LEDs (4 to 6) are the same for all channels.
1 On/off button: This button is lit green when the receiver is switched on and ready for use. It
is sufficient to switch off the receiver to switch off the DMS70 system. Switching off the
receiver switches off all transmitters connected to this receiver.
2 VOLUME potentiometer: This potentiometer allows continuous adjustment of the audio
output level on this channel (10). The Mixing Function means that this potentiometer also
influences the sum output (9) on the DSR70 Quattro.
3 CONNECT: This button has two functions:
Press briefly: to check the transmitters assigned to this channel.

Press and hold down (approximately 2 seconds): to assign a transmitter to a free

channel or to register a transmitter on this channel.
4 LOW BATT. LED: This LED lights up when the batteries of the transmitter registered on this
channel are flat. If the LED starts to flash red the battery will be flat within about one hour.
Replace with new batteries as soon as possible.
5 STATUS LED: This LED lights up green if a registered transmitter is active on this channel
and is ready for operation. The LED flashes green during the channel identification and
channel assignment processes.
6 CLIP LED: This LED lights up red if the audio level on this channel is too high.
7 Antennas: Fixed transmitter and receiver antennas. The best transmission and reception
performances are achieved when both antennas are pointing upwards in the "normal position"
(see image on the cover page).
7
DSR 70 Quattro
Description
5