Aquathin MEGACHAR BFF-1 Getting Started page 12

2) Lubricate
tank o-ring seal,
as shown in
ure 3. NOTE: use
only silicone lu-
bricant.
3) Attach the pro-
vided upper bas-
ket (bayonet fit)
to the control
valve as shown in
figure 4.
4) Slide the chrome
jacket cover and
cap over the me-
dia tank. NOTE:
For illustrative
purposes
chrome jacket is
not shown in the
figures.
5) Screw the con-
trol valve on the
media tank—
turning it clock-
wise (figure
12 © 2007-2009 Aquathin Corporation. All rights reserved. Rev 20091029
the
fig-
Fig. 3. Lubricate the tank o-ring.
Fig. 4. Make sure the upper basket
locks into place.
the
Fig. 5. While screwing the valve
onto the media tank, make sure the
distributor tube locks into place.
5).