Verify The Tubing And Connections; Check Bypass Connections; Check Flow To Carbon Media Tank; Check Drain Line - Aquathin MEGACHAR BFF-1 Getting Started

VERIFYING THE TUBING AND CONNECTIONS

1. Check Bypass Connections

Once plumbing is completed, with
the bypass/service knob in the
"bypass" position as shown in
figure 12, open the main water
supply valve and check for leaks
in the bypass connection.
Open a cold water tap nearby and let water run for a few
minutes or until the system is free of foreign materials
(usually solder resulting from the installation). Close the
water tap when water runs clean.
If there are no leaks, open the inlet
valve to the water heater and re-
store power or gas setting on the
water heater.
2. Check the Flow to the
Resin Tank
Slowly move the bypass/service
knob in "service" position and let
water flow into the mineral tank.
This is an indication that the unit
has purged itself of all air. See
3. Check the Drain Line
With the regeneration knob already
in "service" position, now rotate the
knob clockwise into "backwash"
position (as shown in
allow water to flow at the drain for
3 or 4 minutes.
16 © 2007-2009 Aquathin Corporation. All rights reserved. Rev 20091029
closed
Fig. 12. turn the bypass
knobs perpendicular to
the valve in order to
"close" it, as shown.
Fig. 13. turn the by-
pass knobs parallel to
the valve in order to
"open" it, as shown.
figure 13.
figure 14) and
Fig. 14. Rotate the
knob until in
"backwash" position
open