Installing The Feed Water Saddle Valve - Aquathin AquaKING RO Owner's Manual

3) Install faucet
according to detailed
diagram in Appendix
C–page 46, insuring
rubber gaskets
place. Tighten lock nut
beneath sink.
compression fitting
parts for connection to
GAC post-filter.

Installing the Feed Water Saddle Valve

The saddle-type valve supplied is intended for use on ⅜"
to ½" copper tubing cold water supply line. It is not
intended for flex lines.
Install on cold water
line only!
1) Turn off the cold
water valve under the
sink or the main valve
for the house.
2) Slide clamp over the
copper tubing and
tighten screw firmly to
hold the clamp in
position.
3) Pierce the copper
tubing by turning the
needle valve handle clockwise until it is firmly seated.
4) The valve is closed in this position. Turn on the MAIN
supply valve to pressurize cold water line. Immediately
check for any signs of leaks.
5) Set aside compression fittings for later use connecting
yellow feed tubing to system.
11 © 2009 Aquathin Corporation. All rights reserved.
Hi Speed Dremmel Tool
Silicon/Carbide
Grinding Wheel
Porcelain
are
Sink
Save
Metal
Figure 2, Using a Dremmel® Tool to
Remove Porcelain
Figure 3, Feed Water Saddle Valve
Sink Top
Standard ¼"
Compression
Fittings