Jacobsen Eclipse 2 Technical Manual page 6

Hide thumbs Also See for Eclipse 2:
Table of Contents

Advertisement

Available languages

Available languages

1
SAFETY
d
Do not remove battery pack without unit on
kickstand.
e
Never allow persons to service the mower or its
attachments without correct instructions.
f
When the mower is parked, put into storage or left
without an operator, lower the cutting device unless
a positive mechanical lock is used.
g
When you put the mower on a trailer or put the
mower in storage, close the fuel valve. Do not keep
fuel near flames or drain the fuel inside a building.
h
Disconnect the battery before you service the
mower. Always disconnect the negative battery
cable before the positive battery cable. Always
connect the positive battery cable before the
negative battery cable.
i
Charge the battery in an area with good airflow.
The battery can release hydrogen gas that is
explosive. To prevent an explosion, keep any
device that can cause sparks or flames away from
the battery.
j
Disconnect the battery charger from the power
supply before you connect or disconnect the
battery charger to the battery. Wear protective
clothing and use insulated tools when you service
the battery.
k
Be careful and wear gloves when you check or
service the cutting unit blades. Replace any
damaged blades, do not try to correct a damaged
blade.
l
Keep your hands and feet away from parts that
move. Do not adjust the mower with the engine in
operation, unless the adjustment needs the engine
in operation.
m
Carefully release the pressure from components
with stored energy.
n
Keep the mower and the engine clean.
o
Allow the engine to become cool before storage
and always remove the ignition key.
p
Keep all nuts, bolts and screws tight to make sure
the equipment is in safe condition.
q
Replace worn or damaged parts for safety.
Replace damaged or worn decals. Only use parts,
accessories
and
Jacobsen.
r
To decrease the fire hazard, remove materials that
burn from the engine, muffler, battery tray and fuel
tank area.
6
attachments
approved
s
Disconnect the battery and controller connectors
before you weld on this mower.
WHEN YOU PUT THE MOWER ON A
TRAILER
a
Be careful when you load or unload the mower on
a trailer. Trailer must be wider than the mower and
can carry the weight of the mower.
b
Use a full-width ramp to load or unload the mower
on a trailer.
c
Use straps, chains, cables or ropes to fasten the
mower to the trailer. Both front and rear straps
must be sent down and toward sides of trailer.
d
Make sure that all latches are correctly fastened.
by

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents