Samsung SNR-6400 User Manual page 89

Build RAID1: 48.8%
Finish: 37.6min
RAID1 Setup
[DONE]
Unbuilding RAID
is in Progress...
Rebooting system
is in Progress...
Unbuilding RAID
[DONE]
If the HDD is already set to the new RAID mode, the following message appears.
Current HDD mode is
RAID1 mode
Current HDD mode is
Normal mode
Check HDD mode and
Please Try Again!
If the number of equipped HDDs is not enough, the following message appears. RAID1
requires at least 2 HDDs to be equipped next to each other, HDD1 and HDD2, or HDD3 and
HDD4, and RAID5 requires all 4 HDDs to be equipped.
There are not enough
HDD to build RAID5
Check HDD mode and
Please Try Again!
RAID (Redundant Array of Independent Disks) helps you keep data safe in
case the system HDD is damaged.
Selecting RAID1 configures HDD1 and HDD2 as one array, and HDD3 and
Note
HDD4 as the other array. RAID1 uses 2 physical HDDs as 1 functional HDD.
For instance, configuring HDD1 and HDD2—while each is equipped with a
500GB HDD—to RAID1 displays the system's functional HDD as one 500GB
RAID. In the RAID1 mode, no data is lost even if one of the two HDDs of a
(When RAID1 or RAID5 is selected.)
(When Normal is selected.)
87
User's Manual