Chapter 4: Operations And Settings; Dip Settings; Unit I.d. Settings - Elan V8 Installation Manual

V8
INSTALLATION MANUAL
Chapter 4: Operations & Settings
DIP Switch Settings - UNIT ID
Consult the chart below to determine the correct UNIT ID DIP switch settings. These settings determine which out-
put commands a particular unit responds to. V8s set to UNIT ID 1 will respond to commands specifying Outputs 1-8,
UNIT ID 2 responds to commands specifying Outputs 9-16, etc.
Unit ID
1
2
3
4
Page 16
Zones
1-8
9-16
17-24
25-32
Table 4-1: Unit ID Settings
Unit ID #1
1 2 3 4
1 2 3 4
Unit ID #3
Figure 4-1: Unit ID Settings
Switch #1
OFF/UP
OFF/UP
ON/DOWN
ON/DOWN
Unit ID #2
1 2 3 4
1 2 3 4
Unit ID #4
© ELAN Home Systems 2009 • All rights reserved.
E L A N H O M E S Y S T E M S
Switch #2
OFF/UP
ON/DOWN
OFF/UP
ON/DOWN