Table of Contents
Advertisement
V8
E L A N H O M E S Y S T E M S
INSTALLATION MANUAL
Control Connections - IR
There are two ways to send IR to the V8 using the 3.5mm IR IN port. The IR OUT port passes any IR signal that is sent
to the V8's IR IN port.
IR IN Port
Most ELAN multi-room applications will utilize the rear IR IN port for IR control. Use a 3.5mm mono interconnect
cable to connect between an IR OUT port (typically an 'ALL' port) of an ELAN multi-room controller and the IR IN port
of the V8. In this configuration, any IR signal sent from any zone of the multi-room system will be sent to the V8.
ELAN Multi-Room
Controller
V8
Figure 3-2: IR IN
An IR Receiver such as the ELAN IRS5 may be plugged directly into the V8 to allow for individual room control or
system-wide control using V8 discrete IR codes. See Figure 4-4: IR PWR DIP Settings to enable IR Receiver Power.
V8
Figure 3-3: IR IN using ELAN IRS5
© ELAN Home Systems 2009 • All rights reserved.
Page 11
Advertisement
Table of Contents
