Table of Contents
Advertisement
[301] Command and Control Toggle Options
|____| [1] Reserved Default ( )
|____| [2] Reserved Default ( )
|____| [3] SMS Command and Control Default (ON).
|____| [4] Reserved Default ( )
|____| [5] SMS Character Format
|____| [6] Long SMS Message Handling Default (OFF)
|____| [7] Reserved Default ( )
|____| [8] Reserved Default ( )
[311] - [318] SMS Phone Number 1 - 8
This section may be programmed through DLS 5 or
the keypad.
____________________________________
[321] - [328] SMS Phone Number 1 - 8 Toggle Options
|____| [1] SMS Notification Alarm/Restore Default (OFF)
|____| [2] SMS Notification Tamper/Restore Default (OFF)
|____| [3] SMS Notification Opening/Closing Default (OFF)
|____| [4] SMS Notification System Maintenance Default (OFF)
|____| [5] SMS Notification System Test Default (OFF)
|____| [6] SMS Notification Internal Events Default (OFF)
|____| [7] SMS Notification Enabled Default (OFF)
|____| [8] SMS Command and Control Enabled Default (ON)
[601] Stay Arm
Default (Stay Arm);
Send this command to the system to stay arm.
____________________________________
[602] Away Arm
Default (Away Arm);
Send this command to the system to away arm.
____________________________________
[603] Night Arm
Default (Night Arm);
Send this command to the system to night arm.
____________________________________
[604] Disarm
Default (Disarm);
Send this command to the system to night disarm.
____________________________________
[605] - [608] Activate Command Output 1 - 4
Default (Activate Command Output n);
Send this command to the system to activate a command out-
put.
____________________________________
3G Alarm Communicator Installation Manual
[609] - [612] Deactivate Command Output 1 - 4
Default (Deactivate Command Output n);
Send this command to the system to deactivate a command
output.
____________________________________
[613] Bypass
Default (Bypass);
Send this command to the system to bypass a Zone.
____________________________________
[614] Unbypass
Default (Unbypass);
Send this command to the system to unbypass a Zone.
____________________________________
Send this command to the system to unbypass a Zone. This
command should be followed by the Zone label or Zone
number and Access Code. [615] Status Request
Default (Status Request);
Send this command to request the status of the system.
____________________________________
[616] Alarm Memory Request
Default (Alarm Memory Request);
Send this command to request the alarm memory from the sys-
tem.
____________________________________
[617] Help
Default (Help);
Access Code is not required.
____________________________________
[619] Keypad Message
Default (Keypad Message);
[Account Label] _______________________
[Date and Time] _______________________
[SMS Function] _______________________
[Response] ___________________________
[Message Text]________________________
[621] Function Successful
Default (Successful);
Example: "stay armed successful."
____________________________________
[622] Function Unsuccessful
Default (Unsuccessful);
Example: "stay armed unsuccessful."
____________________________________
[623] Invalid Command
Default (Invalid Command);
Unprogrammable, enter correct command.
____________________________________
[624] System Stay Armed
Default (Stay Arm);
Included in the response message if the command was not
accepted as a valid SMS command.
____________________________________
[625] System Away Armed
Default (Away Arm);
Included in the response to a status request command if a par-
tition is away armed.
____________________________________
28
Advertisement
Table of Contents
