BT Diverse 3010 Classic User Manual page 55

Diverse 3010 User Guide
No display appears
Is the handset switched on?
The battery may be flat or dead.
Recharge or replace the battery.
No dial tone
Is the telephone line cord plugged into
the phone socket and the base station?
If other handsets are registered on the
base, the outside line may already be in
use. Wait until the call is finished and
try again.
The symbol is flashing or you
cannot link up with the base station
Is the handset registered with the base
station? To register the handset, see
page 43. Is the power cable connected
at the base and the power switched on
at the wall socket?
If you press the PHONE button whilst
is flashing, you will hear four short
beeps from the handset.
If you go out of range of a base station
for a long time while your handset is
switched ON, it may take more than
20 minutes to 'find' the base station
again when you come back within
range. However, by simply switching
the handset OFF for a moment, and
then ON again, it will find the base
station within a few seconds.
22/3/01 1:34 pm
Diverse 3010 ~ 4th Edition ~ 28th February ~ 3722
Note
Page 51
The base station or handset does
not ring
The ringer volume may be set too low,
or switched off at the base station.
To adjust the ringer volume at the
handset or base station, see pages 32
or 33 respectively.
Is the telephone line cord connected
correctly? See page 11.
Can't get through, even though a
dialling tone can be heard
You may be set to the wrong signalling
method. To change between TONE
and PULSE dialling, see 'Connected to
a switchboard', page 40.
Handset beeps
Are the handset batteries low? You will
hear a beep every 30 seconds.
If is flashing?
You will hear four short beeps when
you press the PHONE button. Check you
are still in range of your base station.
Buzzing noise on my
Radio / TV/Answering Machine / PC
Diverse is too close and is causing
interference. Move it further away.
51