Table of Contents
Advertisement
ELECTRICAL WIRING — MILLIVOLT
CONNECT REMOTE RECEIVER
THESE INSTRUCTIONS SUPERCEDE THE SECTION
ENTITLED "HEARTH MOUNT" IN THE MILLIVOLT
HAND-HELD REMOTE INSTRUCTIONS SUPPLIED
WITH THE REMOTE.
Figure 17
1. Remove bottom control door.
2. Connect the remote connector wires located in the unit
to the remote receiver.
3. Stick Velcro
®
pads with self-adhesive backing to bottom
of remote receiver and to fl oor of compartment behind
access panel.
4. Attach remote receiver to fi rebox with Velcro
Control switch must face forward.
NOTE: Do not place remote in combustion chamber,
only the remote receiver.
CHECK SYSTEM OPERATION
The millivolt system and individual components may be
checked with a millivolt meter having a 0-1000 mV range.
Conduct each check shown in chart below by connection
meter test leads to terminals as indicated.
A. COMPLETE MILLIVOLT SYSTEM CHECK
("A" Reading: Thermostat contacts CLOSED,
control knob "ON," main burner should turn ON)
a. If the reading is more than 100 millivolts and the
automatic valve still does not come on, replace the
control.
b. If the closed circuit reading ("A" reading) is less than
100 millivolts, determine cause for low reading, pro-
ceed to Section B below.
Check
Test
A
B
20308011
®
pads.
Connect Meter
To
Leads to
Test
Terminals
Complete
2 & 3
System
Thermopile
1 & 2
Output
Figure 17 -
Install Remote Receiver
B. Thermopile Output Reading Check
("B" Reading: Thermostat contacts OPEN, main
burner OFF)
1. Check gas pressure to the unit. If gas pressure is
within minimum and maximum on data plate, then
check pilot voltage, 325 millivolts minimum. If the
minimum millivolt reading is not obtainable, replace
pilot.
Switch or
Thermostat
Meter Reading
Contacts
Should Be
Closed
Open
VFC Vent Free Fireplace System
Remote Receiver
Closed
Open
15
Advertisement
Table of Contents
