FLIR Navigator II Operator's Manual page 12

JCU DESCRIPTION
ON/OFF – turns the Navigator II on and off. When the On/Off
switch is turned to the On position, 2 FLIR splash screens will display for
5 seconds each. After this, the infrared image will display, and the system
is ready for operation. Note that the Navigator II will still draw a small
amount of power when off.
JOYSTICK – allows the operator to control where the Navigator
II is looking. Move the Joystick to the left or right to rotate the camera in
the corresponding direction; tilt it forward and back to tilt the camera up
and down.
DIM – controls the brightness of the JCU panel; this control is active
any time power is on. Dimming the control helps to protect the operator's
night vision. Simply press the button to cycle through the four preset
brightness levels.
HOME – the Home position is a user-programmable set of pointing
angles, usually 0°-0° (straight ahead and level with the horizon), that
operators can use as a reference and as a rest position when navigating
for long periods. To set the Home position, use the Joystick to point the
camera's line of sight to the position you want to set as "Home," press
and hold the HOME button for 4 seconds, and the Navigator II will save
this position as Home. (When the Home symbol flashes, the new Home
position has been saved to memory.) When you want to drive the camera
to this Home position, press and release the HOME button.
www.actoolsupply.com
www.actoolsupply.com
12