Leckey KIT User Instructions page 40

8.22 Hi-low Chassis –
Height Adjustment
You can carry out this adjustment with the
user in the chair. If your chassis has the foot
pedal locking pin (A), disengage it first. To
unlock, pull the pin out and rotate through 90
degrees. To adjust the height of the hydraulic
Hi-low chassis press the foot lever (B) at the
rear of the chassis. Once you remove your
foot from the pedal, the seat will be fixed at
this height. To lower the height place foot
under the pedal and lift up, the seat height will
gradually lower.
For safety always engage the pull pin (A)
after adjustment, if applicable.
A
To adjust the height of the powered base,
use the buttons on the handset. Before
the product is used for the first time, it is
recommended that the battery is fully charged
for 12 hours. To do this, plug the adaptor
into the mains socket and attach the lead
to the battery. Switch on the mains power
supply. When charged, switch off the mains
power supply, remove the adaptor plug and
disconnect the lead from the battery. The
battery charge should be topped up each
day until the green light on the charge is
illuminated. The chair can be adjusted while
attached to the mains.
Ensure that the product and user are
away from surrounding furnishings when
adjusting the height to prevent possible
collisions and injury to the user or damage
to the product.
B